Summary

This strainer has been design to be sturdy and to filter smaller element than the main strainers.

The gaps are about 2mm wide, which keep a goood water flow while filtering.

Can be scaled up/down to fit your sink drain.

All other characteristics are shown on the attached drawing.

Any question or custom design can be ask in DMs.

Have a great day and keep on printin' !

Print Settings

Printer:

BambuLab P1P

                                            Rafts:                      
Doesn't Matter

Supports:

Yes

                                            Resolution:                      
0.2mm

Infill:

100% to 20%

                Filament:                                     Doesn't Matter PETG or ABS                                    Doesn't Matter                    
                        Notes:                     Print upright to have nice finish on the top surface and the supports on the bottom (hidden)

Do not use PLA or other low heat resistant filament. Hot water will make it warp easily!