Print Profile(1)
0.2mm layer, 3 walls, 15% infill
Designer
7.5 h
9 plates
Boost
3
7
6
0
34
48
Released
Description
I just added some variants of this beautiful photo frame by wuguigui. Thanks to wuguigui for sharing this model. You can find detailed information in the original model description.
Comment & Rating (6)
All
Print Profile
0.2mm layer, 3 walls, 15% infill
I had a problem sticking to the table. It's probably my fault. The fill rate for the pin remains low.
0
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
I had to reduce the model by 0.5%, but otherwise the profile prints well.
The designer has replied
0
Reply
Which one of them?
0
Reply
Replying to @CTeipen
All of them.
0
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
The designer has replied
0
Reply
You got some advice for improvements?
0
Reply
No more
This remix is based on
License
This work is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRelated Models
© 2024 MakerWorld