This is a charging stand for the Google Pixel Watch 2.

Edit: Added a v2 which features much less open space at the bottom of the ring and made the ring flush with the stand. This version is a bit of a tighter squeeze, so I'll be leaving the original available as well.

Printed with supports for the main body, I also used a raft for better bed adhesion although this is almost certainly unnecessary.

Assembly is straight forward:

• String the cable through the main body via the charger opening
• Slide the inner ring around the charger
  • This is directional and is intended to have the inner channel facing towards the front, this ensures that the charger is inline/proud of the face to make charging easier.
  • If you have issues getting the watch to attach to the charger, pop the ring out and reverse it.
• Press the charger firmly into the main body,
  • this is a press fit to ensure the ring doesn't move but should slide relatively easily
• Pull the charging cable taunt along the channel on the bottom of the stand and slide on the bottom panel.

Removing the charger assembly can be done easily with a flathead screwdriver through the bottom opening after removing the bottom plate.

Printer Settings:

• Ender 3v2 Sprite (Direct Drive Extruder)
• Filament: eSUN ePLA-Lite
• Slicer: Cura
• Supports: Yes (Main body only)
• Bed Adhesion: Raft
• Layer Height: 0.28mm
  • Initial Layer Height: 0.2mm
• Bed Temp: 60C
• Infill: 18%
• Pattern: Cubic Subdivision
• Print Speed: 85 mm/s
• Print Cooling Enabled