After careful measuring and precise design of subtracted material this is a lightweight and NO SUPPORT NEEDED print that, with a normal printer, can print in about 4-6 hours according to settings. I used .2mm layer height and, for myself, 100% infill just because, but less can be used for whatever you feel comfortable with. This is for my PSVR aim controller for the farpoint videogame to be mounted on my wall which lookes very sleek and blends in nicely and makes my wall pop with some character. additional and iconic (triangle, circle, X, square) playstion logo has been added into the front of the mount for extra profesional look and design. Thank you so much for your interest in my work and happy printing!
Printer:
Raise 3D N1
Rafts:
No
Supports:
No
Resolution:
.2mm
Infill:
30-100%
Notes:
use whatever screws best suit your print and your wall but it does not require heavy duty screws as the mount itself with the aim controller does not weigh a lot. only 3 standard screws will do nicely with plastic drywall anchors.