3D printed YOKE
https://cults3d.com/en/3d-model/game/sim-yoke
The Yoke was inspired by Daher TBM 930. It uses two AS5600 sensors on the pitch and roll axis, 160 degrees total roll turn, 80 degrees from center to each side, 140mm travel for the pitch, 70mm from center to each side. And the most important thing that makes this work....
joystick board from TLN elettronica, the 8AI-36DI with pins. THE BEST BOARD I HAD SO FAR
This unit is stand alone and does not include the throttle quadrant.
Despite how complicated it looks, it is very simple to assemble. I'm no expert in electronics or programming or soldering.
Very little soldering required, or even none if you have the right tools.
So if I could do it, anyone can do it.