Underdesk PS5 Controller Holder
Copyright Claim
Underdesk PS5 Controller Holder
Boost
26
48
19
Print Profile(1)
(PLA) 0.2mm, 6 walls, 25% infill
38 min
1 plate
Boost
26
48
19
0
139
137
Released
Description
Hang ya PS5 controller under the desk by its joysticks
Double sided tape or a couple screws
Comment & Rating (19)
All
Print Profile
(PLA) 0.2mm, 6 walls, 25% infill
passt sehr gut 👌
1
Reply
Print Profile
(PLA) 0.2mm, 6 walls, 25% infill
very good
0
Reply
Print Profile
(PLA) 0.2mm, 6 walls, 25% infill
this print was amazing. I did it as kind of a test for a new filament roll and everything came out beautifully
1
Reply
Print Profile
(PLA) 0.2mm, 6 walls, 25% infill
The print came out very clean. Really good to print even in PETG. Unfortunately, the controllers suffer a bit when parked in the fixture. It might just be me, but I experienced stick drift issues after a week.
0
Reply
Print Profile
(PLA) 0.2mm, 6 walls, 25% infill
Great!
0
Reply
Print Profile
(PLA) 0.2mm, 6 walls, 25% infill
0
Reply
Print Profile
(PLA) 0.2mm, 6 walls, 25% infill
0
Reply
Print Profile
(PLA) 0.2mm, 6 walls, 25% infill
0
Reply
Print Profile
(PLA) 0.2mm, 6 walls, 25% infill
0
Reply
Print Profile
(PLA) 0.2mm, 6 walls, 25% infill
0
Reply
License
This work is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRelated Models
© 2024 MakerWorld