Remix to fit my Photon S powert supply, type TDX Power TDX-1206000.
Made to fit the smaller powersupply and added vent holes. As an electrical engineer I am not a fan of enclosing PSUs with tight fitting holders... I have found them to last longer if they can get rid of their heat.
Mount it using two 3x16mm (or longer) wood screws
Edit; Pretty much ignore v1, it is not quite the right. Size v2 is actually a tad lower (2mm) and longer (17mm) to better fit this type of PSU. I changed the width on the original design, but didn't check lenght and height... Doh!
Printer:
FLSUN QQ-S
Supports:
Yes
Resolution:
0.2
Infill:
15%