SUNLU S1 Dryer Lid Opener
Copyright Claim
SUNLU S1 Dryer Lid Opener
Boost
8
13
10
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
10 min
1 plate
Boost
8
13
10
0
27
16
Released
Description
This little helper leaves the lid of the Sunlu S1 filament dryer open a gap so that the moisture can get out. This significantly speeds up the drying process.
Simply stick it on like in the photo and you're done.
----------------------------------
Dieser kleine Helfer lässt den Deckel des Sunlu S1 Filament Trockner einen Spalt offen, so dass die Feuchtigkeit raus kann. Dadurch wird der Trockenvorgang deutlich beschleunigt.
Einfach wie auf dem Foto drauf stecken und fertig.
Comment & Rating (10)
All
Print Profile
0.2mm layer, 2 walls, 15% infill
serves its purpose. now waiting to see if it makes a difference. I printed two, one for each side. may I make a remix suggestion? make a bar like piece, attaching two together so it’s more covienent to install and less like to lose, due to small pieces!! I’ll check back.nice work and thank you.
The designer has replied
0
Reply
Thank you for the great suggestion. I would be happy to implement it and then publish it here.
(Edited)1
Reply
Replying to @apropo
thank you!!
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Super simple and printed in just a few minutes
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
I can use it for my filament drier.
0
Reply
Auf dem Foto ist ein Hygrometer in das SUNLU eingebaut. Gibt es dafür auch eine Vorlage?
The designer has replied
0
Reply
Das ist das hier https://www.printables.com/de/model/360681-sunlu-s1-filadryer-metermount
0
Reply
It's printed very fast
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
perfecto
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
No more
License
This work is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRelated Models
© 2024 MakerWorld