4 tests in 1 3D Printer Calibration Test - Cancel Object Supported - Low Plastic Waste
Copyright Claim
4 tests in 1 3D Printer Calibration Test - Cancel Object Supported - Low Plastic Waste
Boost
1
3
0
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
49 min
1 plate
Boost
1
3
0
0
8
0
Released
Description
All in 1 test with Cancel object support.
Print using 0.2 layer height
Left bottom square - First layer calibration (Cancel object support)
Right bottom square - Hole tolanace (Cancel object support)
Left top square - bridge test (Cancel object support)
Right top square - wall thickness (Cancel object support)
Comment & Rating (0)
All
No more
License
This work is licensed under a
Creative Commons Attribution-Noncommercial-NoDerivativesRelated Models
© 2024 MakerWorld