EDIT: Just condensed the text of the flowchart to give more clearance for bottle height and tape. Height from shelf top to “Yes” is 124mm (~4.88in) and top of tape peg is now 104.5mm (4.15in)

3D printed version of the joke “Engineering Flowchart”. Put your favorite roll of tape on the left peg and your lubricant of choice on the right shelf. The 3 oz. bottle of WD-40 is slightly too tall and will cover the “Yes”. If anyone is aware of any lubricants that would fit the space better, leave a comment. There are 5mm holes in the top corners for hanging. Prints in about 4 hours with a single color change.

MAKE SURE YOUR BUILD PLATE IS CENTERED! This print has dimensions of 235 x 245 x 72mm, so it is using all available space on the plate while still allowing space for the purge line.

Since there is only 1 color change and not within the same layer, this print is non-AMS compatible. You just need to do a color change on layer 11, assuming .20 resolution

Dimensions:

Width: 235mm (9.25in)

Height: 245mm (9.65in)

Depth: 72mm (2.83in)

Mounting Holes: 5mm each

Top of Tape peg to bottom: ~3.25in Now 4.15in

Tops of Lubricant shelf to bottom of “Yes”: ~3.75in Now 4.88in