Bambu X1C Exhaust Flange (straight) with AMS Hub
Copyright Claim
Bambu X1C Exhaust Flange (straight) with AMS Hub
Boost
19
31
13
Print Profile(1)
0.24mm layer, 3 walls, 15% infill
Designer
2.5 h
1 plate
Boost
19
31
13
4
51
25
Released
Description
I wanted an exhaust flange that would exit center and work with an AMS hub. This exhaust flange is designed to work with 3" pipe, I used semi rigid dryer duct. I hope you can use this model as much as I do! Comment, Like, & Share please.
This exhaust flange is designed to center.
I used small adhesive window foam to seal against the printer. It Is not required but highly suggested.
I used 3x metal pan Phillips screws #4x3/8" and one M3x10 screw to replace the outer factory screw.
Comment & Rating (13)
All
This piece is excellently engineered and printed flawlessly with Overture PLA+.
If you are looking for a 3" duct adapter for your Bambu Lab X1C, and prefer screws over magnets, this is as good as you can get!
Thank you AC , fantastic work on this!
(Edited)The designer has replied
1
Reply
WOW! Thank you for the awesome review! I'm glad you found this model helpful!
0
Reply
Thank you so much! I hope it serves you well.
0
Reply
Print Profile
0.24mm layer, 3 walls, 15% infill
Printed flawlessly with Overture PLA+.
The designer has replied
1
Reply
Thank you for the review! I hope you enjoy.
0
Reply
Boosted
Print Profile
0.24mm layer, 3 walls, 15% infill
perfect if you prefer screws over magnets
The designer has replied
0
Reply
Thank you! I personally do not need to remove the flange often once installed. My cats sometimes like to knock things off with magnets attached :)
0
Reply
Boosted
Print Profile
0.24mm layer, 3 walls, 15% infill
Really nice model! Someone knows what they're doing!!
The designer has replied
0
Reply
THANK YOU!
0
Reply
Print Profile
0.24mm layer, 3 walls, 15% infill
Schrauben passen nicht vernünftig
(Edited)The designer has replied
0
Reply
Please elaborate some on your concern.
0
Reply
Print Profile
0.24mm layer, 3 walls, 15% infill
0
Reply
Print Profile
0.24mm layer, 3 walls, 15% infill
0
Reply
No more
License
This work is licensed under a
Creative Commons Attribution-Share Alike
© 2024 MakerWorld