Chief Helm HALO color a1 mini
Remixed by
Copyright Claim
Chief Helm HALO color a1 mini
Remixed by
Boost
89
126
21
Print Profile(3)
x1 p1 printer _ 0.2mm layer, 2 walls, 15% infill
Designer
42.5 h
1 plate
0.2mm layer, 2 walls, 15% infill
Designer
41 h
1 plate
corrected supports - 0.24mm layer, 2 walls, 15% infill
Designer
37.1 h
1 plate
Boost
89
126
21
5
260
61
Released
Description
nie som autor, remix, foto.
Halo Master Chief Helmet
Comment & Rating (21)
All
Print Profile
0.2mm layer, 2 walls, 15% infill
Could be user error since I am new to 3D printing. little spaghetti on a couple of layers, seems the supports didn't go down right. it fixed it self and isn't too bad so I do not mind. somehow it didn't ruin the whole print
2
Reply
would this print on p1s
(Edited)1
Reply
Replying to @julesmail1101
yeah that is the printer I used
0
Reply
What color was the green?
0
Reply
Print Profile
x1 p1 printer _ 0.2mm layer, 2 walls, 15% infill
support issue cause the very top to fail and have a layer shift. I loved the print but the profile needs to switch to strong supports
1
Reply
Wait, So if you scale it up, is it wearable??
0
Reply
Replying to @ozimandius_117
no, still too small. plus the visor is not transparent. it is solid
0
Reply
Boosted
Print Profile
0.2mm layer, 2 walls, 15% infill
Simply beautiful, right now is watching over my printer :D
The designer has replied
1
Reply
nice 😀👏
0
Reply
This turned out great! .16mm layer height, 10% Gyroid infill. Polymaker Matte Army Dark Green, Polymaker Matte Grey, Polymaker Matte Black, and Polymaker Shiny Gold Silk. If I had a second AMS, I would use an interface layer, that would help the supports at the bottom of the helm. A little rough there because of the amount of supports. But overall easy to clean up, and it turned out great after a nailbiting 75+ hr print!
(Edited)
1
Reply
Is the Master Cheif Helmet wearable? I just wanted to ask before printing :)
The designer has replied
1
Reply
unfortunately this one is not, yes if you increase it to your size.
0
Reply
would this print on the p1s
The designer has replied
1
Reply
yes.
0
Reply
Boosted
Print Profile
x1 p1 printer _ 0.2mm layer, 2 walls, 15% infill
Worked great.
0
Reply
what colors are being used on this print?
0
Reply
Print Profile
x1 p1 printer _ 0.2mm layer, 2 walls, 15% infill
1
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
1
Reply
This remix is based on
License
This user content is licensed under a
Creative Commons Attribution-Share Alike
© 2024 MakerWorld