Monitor hook for earphones
Monitor hook for earphones
Boost
13
26
11
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
21 min
1 plate
Boost
13
26
11
0
140
106
Released
Description
A simple earphone holder for my work headset so it's out of the way.
I attached it to the monitor using 3m tape.
Comment & Rating (11)
All
Print Profile
0.2mm layer, 2 walls, 15% infill
simple designate works amazing
1
Reply
thank you so much.
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
simple hook that works, thanks
1
Reply
cheers for that!
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Ok, dependent on monitor frame width
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
1
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
1
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
1
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
1
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
1
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
1
Reply
No more
License
This work is licensed under a
Creative Commons Attribution-Noncommercial-NoDerivativesRelated Models
© 2024 MakerWorld