Dragon carve art for New Year
Copyright Claim
Dragon carve art for New Year
Boost
136
220
35
Print Profile(3)
0.2mm layer, 2 walls, 10% infill
Designer
12.3 h
2 plates
0.16mm layer, 2 walls, 10% infill, variable layer height
12.4 h
1 plate
dragonround4 Chinese characters height fixed and pre-colored.
10.2 h
1 plate
Boost
136
220
35
0
607
208
Released
Description
A must-have decor for New Year 2024!
A ‘wreath’ of a hi-detailed dragon in chinese antique decorative pattern, to hang on doors or just to give your living room a nice vibe of culture. It says The Year of Dragon in traditional Chinese caligraphy on the wreath.
龍年裝飾環
A stand is included if you are not hanging it up, please print with support.
A version of english writing and another version of chinese words (means a dragon sending its good fortune and vibe) are added.
Comment & Rating (35)
All
Really great model. Printed great with four colors. Black, Red, Copper, and tricolor Red-Black-Gold. 24 hours.
2
Reply
I uploaded a print profile with the four colors separated.
2
Reply
Print Profile
0.16mm layer, 2 walls, 10% infill, variable layer height
This is the most beautiful thing I have printed to date! I used the profile just as described, changed the layer height and turned on variable layer height. Only thing I changed in the model was painting the dragon's right eye red to match the left. Turned out amazing!
1
Reply
Not sure if you can read Chinese. The dragonround4 has some problems as those four Chinese characters are not level (not the same height) and can cause printing problems as shown in the pictures. I have uploaded a 3MF with fixed and pre-colored model to address this issue.
(Edited)
The designer has replied
0
Reply
You are right! I almost forgot there is another version also uploaded. I will look into it later
0
Reply
Just Wow.... 9.6 hours with Sunlu Copper Silk. 0.16 height.
1
Reply
¡Una decoración imprescindible para el Año Nuevo 2024!
0
Reply
红铜（PLA silk）+丝绸红（PLA silk）+黑（PLA）+银（PLA）
0
Reply
I really like how this one came out. I had some issues with the background strings around the ring as the wood pla didnt play nice to print those. But otherwise it went pretty dam good all things considered. I chose a 4 color print with silk so I had to slow it the eff down.. However, the print stated it was going to take 20 hours to print. So I let it run for 8 hours at 50% speed to get the base and more started then this morning I switched it full speed. Altogether it printed for roughly 13 hours. I chose all silk pla except for the outer ring which is done in Dark Walnut PLA. The others are Jade Green, Red & Black combo, and White silk PLA. I did a bit of post processing mostly of the wood pla. But I think it came out fantastic! The pictures do not do it justice lol... Thank you for the design!
(Edited)
0
Reply
Came out amazing! Used Eryone Titanium Dark Gold PLA for the base end Eryone Silk Gold for the Hanzi.
Printed on A1 w/ AMS Lite. 215c/60c bed.
0
Reply
Print Profile
0.2mm layer, 2 walls, 10% infill
somehow failed a few times and the final one has a bad bottom part
0
Reply
Print Profile
0.16mm layer, 2 walls, 10% infill, variable layer height
(Edited)
1
Reply
License
This work is licensed under a
Creative Commons Attribution-Noncommercial-NoDerivativesRelated Models
© 2024 MakerWorld