Simple mould with rounded corners to cast a base slab for your 3D printers.
Do note that for best effect, a layer of foam/rubber is required to act as the dampener.
Intructions:
- Print 4 pieces of “Concrete_Mould_Piece.STEP" - Each takes ~100g of filament.
- Assemble them together and tape them together at the bottom
- OPTIONAL - seal the gaps and seams with silicone
- Apply mould release if you want to have a chance at reusing your moulds
- Pour cement and lay fibre reinforcement
- Wait for it to cure and remove concrete slab