Hueforge filament painting of an eldritch mage.

Print at 100% infill with a layer height of 0.04mm with a base layer of 0.15mm

Filaments Used:
PLA BambuLab Basic Black Transmission Distance: 0.6
PLA BambuLab Basic BambuLab Green Transmission Distance: 8
PLA BambuLab Basic Yellow Transmission Distance: 6
PLA BambuLab Basic Jade White Transmission Distance: 5

Swap Instructions:
Start with Black
At layer #3 (0.23mm) swap to BambuLab Green
At layer #39 (1.67mm) swap to Yellow
At layer #45 (1.91mm) swap to Jade White for the rest.

This was a fun print, and I hope you like it!