GPU Adjustable Anti Sag Support Riser
Copyright Claim
GPU Adjustable Anti Sag Support Riser
Boost
106
205
120
Print Profile(3)
0.2mm layer, 3 walls, 15% infill
Designer
1.2 h
3 plates
A1 Mini - 0.2mm layer, 3 walls, 15% infill
Designer
1.6 h
3 plates
0.2mm layer, 6 walls, 25% infill
1.5 h
1 plate
Boost
106
205
120
3
587
684
Released
Description
Adjustable Graphics Card Support
Is your GPU sagging ? Prevent this by using this fully 3D Printed GPU support.
Prints in about 35 minutes and comes in two different sizes to fit any setup. Locking nut allows you to put the riser in any position securerly
Comment & Rating (120)
All
Thanks!
The designer has replied
1
Reply
No problem :)
1
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
printed fine, works well :)
2
Reply
It's a verry good holder, it works perfectly.
The designer has replied
1
Reply
Looks great !
0
Reply
printed great! I was worried since it was a bit loose screwing it in but once the lock nut was tightened everything became snug! looks pretty good astetically in the pc as well.
The designer has replied
1
Reply
yeah the locking nut is crucial to getting a stable snug fit! looks great 😊
0
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
👍
The designer has replied
1
Reply
Looks awesome :)
0
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
printed in PETG. perfect print!
The designer has replied
1
Reply
Looks great !
0
Reply
Boosted
Print Profile
0.2mm layer, 3 walls, 15% infill
Excellent. I’m glad I could just print a gpu stand instead of buying a overpriced one, prints very well and easily. Only thing i suggest is that the small lock nut doesn’t really need a brim and it stuck to it a bit too well
The designer has replied
1
Reply
Looks awesome ! Yeah it's 50/50 regarding if a brim was needed or not, if I didn't add one people would probably complain it didn't stick ! haha I printed on the textured PEI sheet and it released easily but the smooth sheets may hold it much better.
(Edited)1
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
good
1
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
easy print and the thread runs perfectly top job
1
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
working welling with my 3070
1
Reply
License
This work is licensed under a
Creative Commons Attribution-Noncommercial
© 2024 MakerWorld