The clips on my swag break easily so I designed a new clip with added strength where its needed. The original clip is sewn into the canvas loop so I couldn't retrofit an exact replacement. This design allows the new clip to be fitted to the existing canvas loop and it is surprisingly strong considering the opening at the end where it slides on.

This will fit a 9mm fibreglass pole and could be used for dome tents too, or other things that use fibreglass or aluminium poles. Easily scale to suit your diameter pole within a couple of mm.

This is printed in ABS with maximum perimeters for maximum strength. You could also do 100% infill but maximum perimeters should be stronger (it's debatable) Print on it's side with very small supports needed. I have provided a left and right version although you can use the same print for both sides.

Doesn't Matter

0.2

NA