Yarn Skein Roll
Copyright Claim
Yarn Skein Roll
Boost
44
72
7
Print Profile(1)
0.2mm layer, 3 walls, 15% infill
Designer
12.3 h
1 plate
Boost
44
72
7
0
78
40
Released
Description
We have issues finding the yarn from the center of the skein. This roll allows users to pull from the outside of the skein and have it stay in place. Additionally, there is a lip on the back to place on the edge of a table and hold in place through any tension you have on the yarn.
Print on the edge and you will only need a few basic supports for the yarn hole. I couldn't find a way around this, but if you do, I'd be happy to see it. I hope you enjoy!
Comment & Rating (7)
All
Print Profile
0.2mm layer, 3 walls, 15% infill
Bigger than I expected, I actually ran out of filament, but it came out great! Thank you for making this, will be so helpful! :)
The designer has replied
1
Reply
Glad it worked out. Personally, I like the style of the colors you added. Nice job!
0
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
Printed on my P1P using the provided profile and printed out flawless. It’s a hefty and large model weighing over 400g but the ball of yarn in the pic is a 500g ball so plenty room for bigger balls of yarn. The design means whether it’s sitting on floor or on a table which is where the little lip at back comes into play this thing just doesn’t move. It’s a great design which looks great and required no clean up
0
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
I broke it but it works great after I fixed it. My wife will use it a lot.
The designer has replied
1
Reply
Sorry it broke. Glad your wife enjoyed it. Please let me know if you have any recommendations.
0
Reply
not really and it was my fault for being so rough on it removing the support material
(Edited)1
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
0
Reply
No more
License
This work is licensed under a
Creative Commons Attribution-Share Alike
© 2024 MakerWorld