Bottle Holder Helmet / Helm Flaschenhalter
Boost
84
129
37
Print Profile(2)
0.2mm layer, 2 walls, 15% infill
Designer
1.3 h
1 plate
More Bottle Cups :) 0.15mm layer, 2 walls, 25% infill
Designer
41.3 h
4 plates
Boost
84
129
37
5
240
270
Released
Description
Here is a Bottle closer for Bee`s 😅
Comment & Rating (37)
All
Print Profile
0.2mm layer, 2 walls, 15% infill
not bad. the joint could be a tight fit to allow for the salute to not fall so easily but otherwise works as intended
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
easy to print and its funny at the bottle
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
👍
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Danke!
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
The designer has replied
1
Reply
thanks!
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
(Edited)
0
Reply
Tolle Idee, Druckdauer und Supports machen das Modell aber ganz schön kompliziert. In welchem Material habt ihr gedruckt?
The designer has replied
0
Reply
ja ist richtig, nervt mich auch. habe die Dateien auch noch einzeln aber dann müsste man wieder kleben.
gedruckt habe ich bis jetzt nur in PLA
0
Reply
Braunes PLA paßt besser
1
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Die ältere Generation hat sich sehr darüber gefreut
1
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
sehr schön
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Super Idee!
0
Reply
License
This work is licensed under a
Creative Commons Attribution-NoncommercialRelated Models
© 2024 MakerWorld