Calvin & Hobbes Let It Snow!
For Your Doors.
Use some sticky stuff to keep in place if needed - I didn`t.
The Cover-/Profile Picture shows my Print with Bambu PLA Tough White.
You will get away with any other white PLA on this one.
Don`t let the strange looks in the “Prepare”-Window confuse you.
As soon as you slice you see what it will look like in the “Preview”.
Profile AMS-ready, only two Colours. A1 Mini included.
Easy without AMS, just one swap at 13:
Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm
Filaments Used:
PLA BambuLab Matte Charcoal Transmission Distance: 0.6
PLA BambuLab Tough Cream White Transmission Distance: 10
Swap Instructions:
Start with Charcoal
At layer #13 (1.12mm) swap to Cream White for the rest.
Added STLs for
Bill Watterson, Creator of Calvin & Hobbes, Thank You!
Note: This is Fan Art. Original Drawing didn`t let these snowman-heads fall down your door, they were aligned in the snow.