TicTacToe - KeyChain by Lp3d

Lp3d

Toys & Games>Board Games

Print Profile(6)

All

X1 Carbon

P1S

P1P

X1E

A1 mini

0.2mm layer, 2 walls, 15% infill

Designer

1.5 h

1 plate

4.6(132)

0.05 tolerance model with X, O, and Grid different colors

15.2 h

2 plates

4.8(8)

0.2mm layer, 2 walls, 15% infill

1.6 h

1 plate

4.3(23)

0.2mm layer, 2 walls, 15% infill

2.5 h

1 plate

5.0(3)

Click to see more

Boost

388

669

201

1.2 k

Released

Description

Hello,
here you have my little fun Tic Tac Toe keychain.

Don't forget to calibrate your filament.

A smooth buildplate is recommended.

After printing, the individual fields should release with a slight twist.

Update 21.01.2024

After receiving feedback, I tested different filament manufacturers.

All filaments were calibrated using the same procedure.

Bambu : OK
Extrudr : OK
Esun : Welded
Esun Matte: Ok
Overture : Welded
Sunlu: Welded
and so on……

I tested a total of 8 different manufacturers and 24 colors.

Apparently, the different manufacturers "shrink" differently.
I have therefore uploaded 2 models for which I have increased the tolerances.

+0.05
+0.1

If anyone has a problem with the tight tolerances of the original model, please try a model with the increased tolerances.

Of course, these models have also been tested by me with the materials.

Thanks for your feedback, and happy printing

Comment & Rating (201)

@kevins.emailhub

Print Profile

0.2mm layer, 2 walls, 15% infill

stuck and won’t move

The designer has replied

@Lp3d

I'm sorry that it didn't work for you. If the filament is not well adjusted, or some manufacturers shrink differently, the parts cannot be moved. I have uploaded models with greater tolerance for this. You can find these under the RAW model files. ( Not visible on the mobile APP, only via the browser )

@sage117

Boosted

Try the 0.05 tolerance print profile I uploaded. I have printed out 25+ using and all break free. Depending on where on the plate the piece, it might be slightly harder to break loose a couple squares but everything did. I had also did the 0.1 tolerance but found that after playing with it a while they rotated too much for my liking.

@kevins.emailhub

thanks for the insight, when I get home I’ll give it another try with your recommendations and give an update!