MARIJUANA - CANNABIS FAKE

MOUNTAINS FLOWERS https://cults3d.com/:1896909
meadow flowers https://cults3d.com/:1724465
ORIENT FLOWERS - https://cults3d.com/:1169673
FLOWERS KIT - https://cults3d.com/:1158837

                      All my flowers 

https://cults3d.com/en/design-collections/BIONICFACTORY/colorful-flowers

Quite realistic looking marijuana plant . It is a jigsaw puzzle.To create a similar plant it is necessary to create the same number of leaves as in the photo.

                    PROCEDURE  

Join one piece at a time starting from the base. If the leaves turn so use a second glue . Look at the photo - instruction . There are several types of leaf but there are leaves with a large eyelet which are only for the wider joint . The smaller eyelets are for the smaller joint.

JOINT 1 , joint 2 , starting connector 1 and 2 --- need to turn on in slicer BRIM ! Just use a 2mm width of brim and turn on the brim object gap around 0,1 -0,2 (you can work here) These parts after cleaning require a knife to remove the brim properly so so that you can stretch the ring

These joints must be printed horizontally because of the layers - this way the joints are more resistant to breakage.

Count on the fact that the eyelets are a little harder to put on and this is to keep the leaves from spinning so you must thoroughly remove the BRIM.

 You do not need to place a mallet on top of the plant, but you can leave only the leaves, which you carefully twist upwards with a lighter. Do not place the plant at eye level, but rather lower down.

don't make the plant smaller! :D

For large plant leaves the last 2 layers can be changed in colour
The top strains is modified and hollow

large leaves use 1 wall

All connectors 3 walls

3 top layer
3 bottom layer
Material PLA or PETG
It is necessary to have a well-adjusted first layer or use a printer with automatic calibration