Tamping Station Portafilter
Copyright Claim
Tamping Station Portafilter
Boost
7
26
3
Print Profile(1)
0.2mm layer, 3 walls, 15% infill
Designer
1.1 h
1 plate
Boost
7
26
3
0
48
28
Released
Description
Portafilter holder for tamping. Fits my 61mm outer diameter portafilter.
Check the measurements of your portafilter handle before printing. Some handles have a bigger diameter.
All measurements are available in the drawing.
Comment & Rating (3)
All
Print Profile
0.2mm layer, 3 walls, 15% infill
printed very well, but WARNING: Does NOT fit the breville barista Express portafilter!!!
at least for the one that came in-box with my BES870XL. the neck is too wide on my portafilter.
1000% my fault though, as the creator provided the technical drawings with dimensions
The designer has replied
0
Reply
Oh sorry. I didn't consider different neck sizes. Just measured the one I use.
0
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
0
Reply
No more
License
This work is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
© 2024 MakerWorld