Display Plates Bambulab Filament Swatch Halterung Hexagon
Remixed by
Copyright Claim
Display Plates Bambulab Filament Swatch Halterung Hexagon
Remixed by
Boost
14
45
7
Print Profile(1)
0.2mm layer, 3 walls, 15% infill
Designer
5.6 h
1 plate
Boost
14
45
7
0
57
20
Released
Description
This is a little display holder for eight Bambu Lab Filament Swatch Labeled Display Plates. So there are two empty slots, if you want to print some more plates for your own filament.
I also have a X3D-v3 Riser | Bambu Lab X1/P1 AMS Stand, so I tried to hang it in there. It is designed for the right front side, because i have the plate holder behind and the tool holder on the left side.
For this I used the hexagons from All in one tool holder for AMS Riser v2 v3 and remixed this for only two of three hexagons.
I used rainbow PLA, cause my wife told me so ;) Love u darling…..
Comment & Rating (7)
All
Print Profile
0.2mm layer, 3 walls, 15% infill
Works as intended to hold my swatch displays! prints great!
(Edited)
0
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
printer in abs
0
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
Great design, I used a boolean to remove the hex to just use it on my desk though, you should put up one without the hex mount!
2
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
I did not need the mounting, I just needed it to sit on my desk space - works perfectly.
1
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
1
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
1
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
1
Reply
No more
This remix is based on
License
This work is licensed under a
Creative Commons Attribution-NoncommercialRelated Models
© 2024 MakerWorld