Tired of your toddlers having a sweaty back after riding around in their child car seat? Do your rear air vents super-heat or super-cool your passengers shins due to its wonderfully designed placement?? Do you happen to drive a Jeep Compass because you're a masochist???

Well, this is the print for you!!!

Also, when you're sick and tired of your precious children getting pampered by a stream of nice cool air on a hot summer day, you can shove the vent guide into the bottom of the front driver and passenger seats to cool your moist, swampy plumber's crack.

This vent manifold attachment installs on the inside of the vent trim.

Like all things in a Jeep automobile this rear vent trim is held on by friction and prayers, so all you have to do is pull on it a little bit for it to release from the center console. Remove the two torx screws holding the vents inside the trim piece, install the vent manifold, put the old vents back in making sure they are open and screw them back down. Put your trim piece back in place on the center console. Attach 1 inch ID corrugated hose cut to whatever length you'd like, then install the air guides and clamps using M2 screws and nuts.

I highly recommend printing ASA or PETG. Print the Air Guides with the output side on the build plate. This will get the layer lines oriented for the best strength on the input side. Definitely use brims on the Air Guides.

Wife approval factor: 11/10.