350W Compatible - 2 Spools Filament Dryer for Silvercrest/Quigg 350W Food Dehydrator
Remixed by
Copyright Claim
350W Compatible - 2 Spools Filament Dryer for Silvercrest/Quigg 350W Food Dehydrator
Remixed by
Boost
23
51
8
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
28.2 h
5 plates
Boost
23
51
8
0
52
30
Released
Description
Remixed spool dryer to make it compatible with 350W food dehydrator! Tested with Silvercrest and Quigg components!
Made also some change to the mode:
- PTFE guides moved to the back;
- added PTFE guides to the base instead of the middle part;
- added small feet to the middle part to allow screwing to the base.
To make a full dryer you need the following components.
- Roller(print2).STL → original
- CableLocking.STL → original
- Feet(print4).STL → original
- SpoolDryer_Top.STL → original
- ElectronicsSeparator.STL → remixed
- ElectronicsBox.STL → remixed
- SpoolDryer_Mid.STL → remixed
- Button → new for Silvercrest and Quigg
The one labelled as original you can find at this link: 2 Spools Printable Filament Dryer by AP Engineering - MakerWorld
Substitute the original parts with the remixed one for compatibility with the Silvercrest and Quigg dehydrator.
For details of material needed and a small guide you can refer to the original model.
Comment & Rating (8)
All
Print Profile
0.2mm layer, 2 walls, 15% infill
1
Reply
Great Model, thanks for sharing. where do I find the buttons for your design?
And did you upload the remodeled parts? I printed the bottom and there are no Filament guides.
(Edited)The designer has replied
0
Reply
Hello, indeed you are right. The bottom part I put an older version without the filament guides. I'm sorry for that. I'll upload the modified one.
For the buttons you can find thr stl but I didn't put in the printing profiles. I will add that too. I will made the changes tomorrow cause now I don't have access to my laptop.
Thank you for pointing that out!
1
Reply
Replying to @cuci46
already printed everything and it fit well together. now I have your „old“ model but it worked for me.
the buttons in your raw files were to big for the „old“ model so I designed them myself. but all in all thanks for the great work 🙏
1
Reply
Replying to @Kellermann
Nice!! Happy you liked it and that it works properly!
1
Reply
what is the max drying temperature?
The designer has replied
0
Reply
For this specific dryer the max temperature that can reach is about 70degC.
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
(Edited)
0
Reply
No more
This remix is based on
License
This work is licensed under a
Creative Commons Attribution-NoncommercialRemixes (1)
© 2024 MakerWorld