AMS Lid Grip and Riser v2 Remixed by Brad - FTBT 3D

Remixed by

Brad - FTBT 3D

3D Printer>3D Printer Accessories

Print Profile(2)

All

X1 Carbon

P1S

P1P

X1E

0.24mm layer, 2 walls, 15% infill

Designer

14 min

1 plate

4.3(3)

0.2mm layer, 3 walls, 20% infill 5 top/bottom layer PETG

16 min

1 plate

4.5(2)

Boost

Released

Description

This simple lid grip and riser for the AMS is an upgraded version of the original one I published. This grip fits firmly over the tab on the AMS lid so it'll stay put when you're opening and closing the lid.

Right side up it'll raise your lid about 10mm for larger spools and jumpers. You can also flip it upside down and use it as a grip when you want to close the lid fully.

Print without support. Prints in just a few minutes.

Comment & Rating (5)

@cretz11

Print Profile

0.2mm layer, 3 walls, 20% infill 5 top/bottom layer PETG

work very good!

@D_1uxe

Print Profile

0.24mm layer, 2 walls, 15% infill

Cool model

@VCP3D

Print Profile

0.24mm layer, 2 walls, 15% infill

Alles okay

@mbraaten83

Print Profile

0.2mm layer, 3 walls, 20% infill 5 top/bottom layer PETG

model is simple, printed easily with PETG. Works fine as a bigger handle for the lid, but I found that it doesn’t lift the lid up enough to clear my Elegoo spools with printed adapter rings, so it doesn’t really work for me. Even so, it’s. a nice model and a good idea, just not quite enough clearance for my situation.