This is Winston's Banana Holder!

Hardware Needed:

2x M5*40 Beveled Wood Screw - The Ones I used were on Amazon but are no longer available. An Equivalent US Size should be #10x1.5

1x M5*25 Beveled Wood Screw - The Ones I used were on Amazon but are no longer available. An Equivalent US Size should be #10x1

6x Scotch Rubber Bumpers 3/8" Round - https://www.lowes.com/pd/Scotch-Scotch-174-Clear-Bumper-48-ct-Assorted-Pk/1002964582

Filament Used:

Poly Terra - Cotton White, Fossil Grey, Black

Bambu Labs - PLA Orange

I printed this at .16 Layer Height with 8 top layers to not allow the infill to show through.

I did some sanding on the tip of the holder to cleanup the needed supports and allow the Bananas to hang a bit easier.