MYNT3D Printing Pen Stand by Ocular Dynamic

Ocular Dynamic

3D Printer>3D Printer Accessories

Print Profile(2)

All

P1S

P1P

X1 Carbon

X1E

0.2mm layer, 2 walls, 15% infill

Designer

44 min

1 plate

3.0(1)

Added Support and both versions, 0.2mm layer, 2 walls, 15% infill

2.1 h

2 plates

5.0(2)

Boost

Released

Description

Was looking for a good stand for my Amazon MYNT3D Printing Pen that left the nozzle open if it was still hot. It should put the nozzle about 8mm or so off the surface and only the bigger of the 3 vents on the sizes of the nozzle is covered. PLA should be fine.

I added a second version at a 45 degree angle if straight up and down doesnt work in your situation.

I used PLA, but obviously PETG/ABS would be better.

Supports:

Yes for the center square.

Comment & Rating (10)

@mvgg9hg87y

Print Profile

Added Support and both versions, 0.2mm layer, 2 walls, 15% infill

printed perfect with Bambu Lab Gold PETG. made one of each.

The designer has replied

@robert85

Happy to hear and thank you for your rating. ☺️

@DanPueppke

The stand printed very nicely on the textured plate with PLA. I cut down the rectangular 3D pen holder by 6mm so that it 1. Does not interfere with the feed button. 2. Now, being shorter, while still holding the pen perfectly fine, it will fit in the box with the rest of the parts and equipment, along with perhaps 5 of the filament reels. It is nice now, to have all of the related parts to fit in the OEM factory box for storage, with the lid closed by the magnetic latch.