zusätzlich benötigt:
3x M4x80 Gewindestange Rostfrei
3x M4 Muttern Rostfrei
3x Unterlegscheibe Rostfrei
1x BME280 oder DHT11 oder DHT22
1x Hallsensor auf Platine (https://bit.ly/2YSHArd) oder nur Hallsensor
3x Magnete 5x2mm (aus OCB Papers packung)
2-3x Alte Notebook schrauben (M2,5)
1x 8x40mm rund Aluminium
2x 608ZZ Kugellager
Rotormitte zu bechermette 80mm
falls andere Sensorhalterungen benötigt werden schreibt einen Kommentar
additionally required:
3x M4x80 threaded rod stainless
3x M4 nuts stainless
3x washer stainless
1x BME280 or DHT11 or DHT22
1x Hall sensor on board (https://bit.ly/2YSHArd) or only Hall sensor
3x magnets 5x2mm (from OCB paper pack)
2-3x old notebook screws (M2.5)
1x 8x40mm round aluminum
2x 608ZZ ball Bearing
Center of the rotor to the cup 80mm