Ever wondered what a Darth Vader force ghost would look like over Christmas? Well wonder no longer!

Here's a fun HueForge print of your favourite Father Christmas (get it?) that prints relatively quick, only taking about 2 hours for the entire print. It measures 150mm x 150mm and fits in TheCraftyMaker's HueForge frame as well! Just print the 150mm x 150mm version :)

Print Instructions:

Print at 100% infill with a layer height of 0.04mm with a base layer of 0.2mm

Note: I used Glow in the Dark filament for this one to add a little fun to the print. If you do not want the print to be GitD, replace the GiTD with just plain white :)

Filaments Used:

• PLA Kingroon Black Transmission Distance: 0.4
• PLA Glow in the Dark Green Transmission Distance: 5.2 (or White!)
• PLA CC3D Blue Gray Transmission Distance: 3
• PLA META Sunlu Teal Transmission Distance: 5.4 -PLA Kingroon White Transmission Distance: 8

Swap Instructions:

• Start with Black
• At 0.76mm swap to Glow in the Dark Green (or white)
• At 0.8mm swap to Blue Gray
• At 0.96mm swap to Teal
• At 1.16mm swap to White (Do not swap after this if you do not want the glow!)
• At 1.60mm swap to Glow in the Dark Green (or white)

______________________________________________

If you'd like to support me, I now have a Patreon!

Joining will give you behind the scenes information on WIPs, access to a private discord, early access AND exclusive models!

If you want to sell any physical models I have uploaded anywhere, an unrestricted commercial license is available on the $10AUD tier of my Patreon!

______________________________________________