This design is a side mounting holder/holster for the Milwaukee M12 Fuel 2504-20. It might fit other drills but it's fairly specific to this one. It does not fit the non-Fuel M12 driver well or at all.

The screws should fit #8 flat or round head screws. I used 1.25" long ones (below).

Printing

• Printed on Bambu X1C in Inland PLA+. Might use PETG if not PLA+
• 0.2mm layer heights in 33% infill.
• No supports or brim is needed if oriented on the small round end.
• Want another orientation? Mirror in your slicer.

Items

• M12 Fuel 2504-20 (Amazon affiliate)
• #8 x 1.25" Screws that fit (any #8 flat head should)

Includes Affiliate Links

• Nano Adhesive - Stop using glue sticks - this is 1000% better 😉
• 6mm Magnets
• Plastic Debur Knife - clean up plastic edges (brims)
• Small Clamps
• Assembly Glue
  

PDX CNC Products