Have been using the 2.8-inch touchscreen for a while now and decided to finally remove the original screen. https://github.com/xperiments-in/xtouch
I remixed the one I posted a while back and used the outline of one off of Printables for the back. Added a cutout to access the reset button - just in case. Made it fit close to the frame and only wide enough to cover up the screws in the front plate. This means you cannot use a straight micro-USB cable!
POWER OPTIONS:
HARDWARE REQUIRED:
It will be tight sliding into the front plate, but it will go in. This is by design so it does not vibrate out. Make sure all support material is off of the “legs” before installing.