Poop Scoop
Copyright Claim
Poop Scoop
Boost
64
122
154
Print Profile(1)
0.2mm layer, 1 walls, 0% infill
Designer
2.5 h
1 plate
Boost
64
122
154
0
1.1 k
736
Released
Description
1 Wall Spiralmode
Comment & Rating (154)
All
Print Profile
0.2mm layer, 1 walls, 0% infill
I think I like it, but time will tell. The vase mode print came out a little worbly, but I think it will function fine.
Vase mode is a good idea for material savings and it didn't take long to print. I think maybe the profile would have been improved by slightly slower speed, lower temp or better cooling
The designer has replied
1
Reply
Thank you for your feedback!
The best improvement for this part is a 0,6mm nozzle with a wall thickness of 1,2mm
BR
Armin
(Edited)0
Reply
Print Profile
0.2mm layer, 1 walls, 0% infill
the design was to low so half the poop went over and out
The designer has replied
0
Reply
Thank you for your feedback.
For better result try 0,6mm nozzle and wall thickness of 1.2mm
This design is built to dand in frot of a wall, thas because your poop went out.
0
Reply
Einfach und Gut
0
Reply
Print Profile
0.2mm layer, 1 walls, 0% infill
Super schneller Druck, wenig Material und tut was es soll.
0
Reply
Print Profile
0.2mm layer, 1 walls, 0% infill
Passt gut, jedoch sehr instabil mit nur 1 wand.
0
Reply
Print Profile
0.2mm layer, 1 walls, 0% infill
With only one wall (0,6mm) its walls are wobbly and wavy but it does its job. I taped there two magnets so it wont move away.
0
Reply
Print Profile
0.2mm layer, 1 walls, 0% infill
Exactly what i want. Thx.
0
Reply
Print Profile
0.2mm layer, 1 walls, 0% infill
looks good but not for ludicrous mode
0
Reply
Print Profile
0.2mm layer, 1 walls, 0% infill
L'impression c'est bien passée, mais hauteur du bac à revoir car beaucoup de poop passent au dessus quand ils tombent.
0
Reply
Print Profile
0.2mm layer, 1 walls, 0% infill
Did not worked very well.. printed with polyterra pla. Maybe the profile was too fast for this filament
0
Reply
License
This work is licensed under a
Creative Commons AttributionRelated Models
© 2024 MakerWorld