This is a simple spice tray/rack designed to hold 12 spice glass tubes from Ikea.

The original supports/racks hold four tubes and take up too much space. And they are not really stable to keep on a surface, as they were designed to hang on the wall.

Print instructions

Spice rack printed in PLA.

• 10% to 15% infill
• 3 walls
• 4 bottom and top layers

Rings printed in TPU 95A

• Print 12 rings
• 3 walls, making them ‘solid’
• Use a brim to ensure no warping, even if you have good bed adhesion. The rings are thin and tend to rerelease from the bed.

Assembly

The TPU rings are just inserted into the spice rack. They provide as smoother placement for the tubes. Note that the glass tubes from Ikea are not really accurate in their diameter, so the TPU rings allow for the dimension discrepancies from the tubes.