Thanks to Murray Clark aka muzz64 who shared this Model

https://www.thingiverse.com/thing:1001286

Print-in-Place design of a Scorpion. The tail rotates up and over. The pincers also rotate and, when squeezed, open to grab onto things. Another fun print!

Refer to instructions for print settings to ensure it is strong enough. NO SUPPORT REQUIRED.

After printing, carefully snap/cut away the Raft so you don't damage the legs or Pincers in particular. As soon as the Raft is removed the tail should rotate up and over the Scorpionz back and Princers move and nip/grab onto things. Take care when you first rotate the pincers so they break away cleanly. Just a gentle wriggle / twist should clean it away fine.

The standard design print is approx. 17 cm in length. This could be scaled up but scaling down will not work as it will affect internal clearances and could also make the joints too weak.