Garage Shelf double hook by Ming Yao

Ming Yao

Hobby & DIY>Other Hobby & DIY

Print Profile(2)

All

A1 mini

P1S

P1P

X1 Carbon

X1E

0.2mm layer, 4 walls, 20% infill

Designer

1.2 h

1 plate

4.9(22)

0.6mm nozzle, 0.3mm layer, 4 walls, 25% infill

2.3 h

1 plate

5.0(1)

Boost

148

316

233

161

Released

Description

This hook is designed as an upper and lower hook. The upper hook is larger and the lower hook is smaller. It is suitable for hanging coats and keychains that are often used when going out. You can hang them at the desired height or position as you like.

Comment & Rating (25)

@SpacemanSpiff

Print Profile

0.2mm layer, 4 walls, 20% infill

Works great, I ended up printing it with the nubs to build plate surrounded by support. It made the part that shows a little cleaner, not sure about strength though as the layer lines are now vertical.

The designer has replied

@MingYao

Maybe the sizes produced by each manufacturer will have slight errors. I can provide step files for you to make modifications so that you can modify them to a suitable size. It has been updated earlier. You can download and modify it.

@maker86

Print Profile

0.2mm layer, 4 walls, 20% infill

Great

@Todd.preimesber

Print Profile

0.2mm layer, 4 walls, 20% infill

Worked great.

@KalonsKreations

Print Profile

0.2mm layer, 4 walls, 20% infill

fits exactly as designed

@designbuild

Print Profile

0.2mm layer, 4 walls, 20% infill

I printed this for my shelving only to find out that it doesn’t quite fit the shelving that I have, which really is my fault for not inspecting it more carefully. The breakaway supports came off, easily without damaging the hook.

@jellybeanbandit

Print Profile

0.2mm layer, 4 walls, 20% infill

I printed 6 on a plate and for the 80% that actually printed before one fell over and then slowly took out the rest, it looked great! I'm not sure what happened but I will try again with a slower print to see if it helps. it was great spaghetti though