This is my first HueForge and first upload - it's a photo taken of me riding my Fireblade at Fish Hill. Please feel free to use it for any motorbike fans in your life. The instructions are for BambuLab filament, however the image shown is using Kingroon PLA for the grey and white, you will likely get better results with BambuLab Basic PLA.

Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm

Filaments Used:
PLA BambuLab Basic Black Transmission Distance: 0.6
PLA BambuLab Basic Red Transmission Distance: 5
PLA BambuLab Basic Gray Transmission Distance: 2
PLA BambuLab Basic Jade White Transmission Distance: 5

Swap Instructions:
Start with Black
At layer #8 (0.72mm) swap to Red
At layer #16 (1.36mm) swap to Gray
At layer #20 (1.68mm) swap to Jade White for the rest.