My personally designed PlayStation VR stand was made with sleek style and functionality in mind. Its tilted headband bracket and forehead rest is positioned at such an angle where when strapped on, the VR sits fairly level and facing straight. There are four countersunk holes in the base for small rubber pads (not necessary for use) that can be glued into them for limited sliding on smooth surfaces. The distance from forehead rest to rear strap bracket is slightly larger than the diameter of the inside headset strap to ensure the VR is held firmly in place when at rest. Made with 30% (thirty percent) infill and 3 (three) shells to prevent cracking when self-threading the screws and room for sanding and painting if so desired. Please enjoy and share my design to spread the word, as this is the only singular stand for PSVR made specifically for display. I hope you enjoy my design and happy printing to all of you!
Special thanks to username: (Neovista49) for uploading the Playstation VR logo which I used as the side decal! Its amazing!
Printer:
Raise N2 Plus
Rafts:
Yes
Supports:
Yes
Resolution:
0.20mm
Infill:
30%
Notes:
Whichever print setting you so desire is up to you depending on how well your printer works at printing specific details such as layer height or infill but still must have (3 SHELLS) to not crack inside the holes for the screws.
30% infill for a solid structure and three shells to prevent any cracking from occuring when self-threading the screws. you will need 2 (two) 1/8 inch thread width screws with 1/4 inch round head on top.(specific screws not necessary) use any screws that will hold firm the top to the base given the hole sizes.