Was looking for a good pic of a Beagle that resembled mine and I came across this one.

Hueforge charateristics;

Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm

Filaments Used:
PLA PolyTerra Charcoal Black Transmission Distance: 0.3
PLA EL3D Red Transmission Distance: 5
PLA EL3D Grey Transmission Distance: 0.3
PLA EL3D TRI -RED/GRN/BL Transmission Distance: 4
PLA PolyTerra Pastel Peanut Transmission Distance: 0.5
PLA EL3D Yellow Transmission Distance: 6
PLA PolyTerra Pastel Peanut Transmission Distance: 0.5
PLA EL3D Marble Transmission Distance: 4

Swap Instructions:
Start with Charcoal Black
At layer #14 (1.2mm) swap to Red
At layer #16 (1.36mm) swap to Grey
At layer #18 (1.52mm) swap to TRI -RED/GRN/BL
At layer #19 (1.6mm) swap to Pastel Peanut
At layer #25 (2.08mm) swap to Yellow
At layer #26 (2.16mm) swap to Pastel Peanut
At layer #27 (2.24mm) swap to Marble for the rest.