Valentines Day gift box, (Heart hands)
Copyright Claim
Valentines Day gift box, (Heart hands)
Boost
74
113
21
Print Profile(4)
0.2mm layer, 1 walls, 15% infill
Designer
3.2 h
2 plates
0.2mm layer, 4 walls, 15% infill
1.6 h
1 plate
0.2mm layer, 1 walls, 15% infill
3.1 h
2 plates
0.2mm layer, 1 walls, 15% infill
2.5 h
2 plates
Boost
74
113
21
0
166
172
Released
Description
This is a fun gift box for valentines day or any occassion. Great to fill with candy, giftcards or cash. The print only reqires 3 colors and is modeled to be printed on a textured build plate face down.
Comment & Rating (21)
All
Print Profile
0.2mm layer, 1 walls, 15% infill
Nice for gift!
(Edited)
0
Reply
Print Profile
0.2mm layer, 1 walls, 15% infill
perfekt *****
0
Reply
Print Profile
0.2mm layer, 1 walls, 15% infill
great model and print profile
0
Reply
Print Profile
0.2mm layer, 1 walls, 15% infill
(Edited)
0
Reply
hello so can u put chocolates in it thwt are the size of a inch cause I wanna give this to my mom for valetines
The designer has replied
0
Reply
what are the exact dimensions and I can check if it would fit. like an inch long, wide or tall?
0
Reply
Replying to @Atyourleasurepr
oh wait super sorry I was commenting to the wrong print I think
0
Reply
Print Profile
0.2mm layer, 4 walls, 15% infill
Nice design. Lid is just a bit tight. You could scale it down a tiny bit before printing.
The designer has replied
1
Reply
mine fit perfectly. I likes the tight fit so they don't fall off in the kids bags :)
0
Reply
Hello, It changes filament\color 21 times?
The designer has replied
0
Reply
I believe so it has to change colors for each layer on the top part of the lid
0
Reply
Print Profile
0.2mm layer, 1 walls, 15% infill
archivo, perfecto, unicamente señalar las ranuras de color del ams lite y hecho en un rato. un 10.
0
Reply
Print Profile
0.2mm layer, 1 walls, 15% infill
Strength Issue:unsure why it under extruding on this model only, withe the same spool that's been used for every print for 3 weeks. but two tries on this model (THE BOX PORTION)and both are HORRIBLE
The designer has replied
0
Reply
make sure you select the use your own filament settings underneath the part when you go to print the model from the app. I always select this so I can make sure the filament settings are for the specific rolls I use
0
Reply
Print Profile
0.2mm layer, 1 walls, 15% infill
0
Reply
License
This work is licensed under a
Creative Commons Attribution-Noncommercial-NoDerivativesRelated Models
© 2024 MakerWorld