Creality K1 and K1 Max Bed Leveling Spacers by needitmakeit

needitmakeit

3D Printer>3D Printer Parts

Print Profile(2)

All

P1S

P1P

X1 Carbon

X1E

PLA - 0.08mm layer, 2 walls, 15% infill

17 min

1 plate

4.9(15)

ABS - 0.08mm layer, 2 walls, 15% infill

20 min

1 plate

5.0(5)

Boost

866

129

Released

Description

I designed these as a quick and simple way to level the bed on your K1 or K1 max so that you can get it far closer to level than would be possible using the method Creality recommends. This is super simple, quick, and uses next to no filament.

I would recommend printing these with a LH of 0.08mm. and I would suggest PETG or ABS/ASA to make sure that they are not impacted by the heat within the build-chamber.

NOTE** Print before you take your printer apart, if that wasn't already a given.

Comment & Rating (27)

@frosties

Print Profile

PLA - 0.08mm layer, 2 walls, 15% infill

Worked perfect for raising it 0.1mm, thanks!

@Rick269

Boosted

Print Profile

ABS - 0.08mm layer, 2 walls, 15% infill

Great concept and design is spot on.

@r.salinas

Worked Great.

(Edited)

@user_144780595

I like using the 1.0 mm tab and just scaling it to whatever I need. E.g. if you need 1.4mm, then scale it on the z axis in your slicer at 140%. 0.77mm = 77% etc.

(Edited)

@user_4139826773

Thank you

The designer has replied

@needitmakeit

You're welcome! I hope it helped.

@markurian

Do not print these in PLA. PLA goes soft at 60c, and even when cold, will squash/compress when under pressure. I found this out the hard way when I printed custom stand-offs for my Ender 3 v3 SE print bed.

The designer has replied

@needitmakeit

Yup, ABS and PETG. The chamber temp will get a little too warm, and radiant heat from the bed will soften PLA. Thanks for the note!