Universal Vertical Monitor Stand
Universal Vertical Monitor Stand
Boost
20
31
4
Print Profile(2)
0.2mm layer, 3 walls, 20% infill
Designer
2.3 h
1 plate
0.2mm layer, 6 walls, 25% infill
Designer
42 min
1 plate
Boost
20
31
4
1
73
45
Released
Description
Stand for vertical use on any flat monitor. Two stands are enough to hold the screen.
Print instructions:
STAND
Lay on the side
No supports needed, make sure you don't have any drafts on the bed when printing so turn the aux fan off.
SCREWS
The screws have a print in place ball joint so place the screws vertical.
No supports needed.
Comment & Rating (4)
All
Boosted
Great design. Holds my monitor in portrait mode close to the table. Just what I needed.
(Edited)The designer has replied
1
Reply
Thanks! I'm really glad it worked for you :D
0
Reply
Print Profile
0.2mm layer, 3 walls, 20% infill
0
Reply
Print Profile
0.2mm layer, 3 walls, 20% infill
0
Reply
No more
License
This work is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
© 2024 MakerWorld