Got the idea from sstrange https://www.thingiverse.com/thing:4883798
The original does NOT fit the included GE Opal 2 countertop ice maker scoop. It is about .75" too short and width too tight.
I didn't like how short the bottom scoop portion was.
I needed it to be taller and wider anyway to fit the factory scoop so redesigned to be taller on the bottom half for both functionality and aesthetics.
-When printing, to strengthen the ears, the object is split into sections. Section with the ears has more wall loops and more infill.
-To assemble, gently use a heat gun to warm up the ears so they do not break when pushing the top nubs into place.
-Glue the small magnets into the top portion.
-The bottom bar magnets can be glued in as well, or use the included 3m tape.
Strong 60x10mm bar magnets for the lower half to reduce sliding
https://www.amazon.com/dp/B07WCBDPMJ/ref=cm_sw_em_r_mt_dp_F5SQ0CGMD03V2VR0PVSS?_encoding=UTF8&psc=1
10x2mm round magnets to the lid is easily pulled back.
https://www.amazon.com/dp/B0753ZPBLQ/ref=cm_sw_em_r_mt_dp_AX0S6VF2B55XK15MMWC8?_encoding=UTF8&psc=1