A left Side Door Seal/Gasket to hide the gap in between the glass and side of the body of the printer. Also to help keep heat in that would otherwise escape from the printer through the gap.
The reveal/gap on mine seemed a little too tight for it to fit open/close well. However the print itself was great. I ran 2 of them they were both successful I’m still impressed with the material and print and it not failing.
had to print 2 and they came out really good. only slight clearance issue at the bottom of the glass between it and the side panel. Ive applied a thin layer of silicon grease. hopefully it loosens up.
Printed great using Bambu Lab TPU 95A HF
Its a tight gap and keeps pulling the seal of when opening and closing the door. I used double sided sticky tape to solve the problem
Wish this worked better for me. The seal doesn't cover the whole door, and in the parts that it does cover it rubs up against the frame causing squeaking.