This pedal chassis and other printable components can be used to create any variable resistor (potentiometer) based audio pedal. My primary objective was to just create an expression pedal that could be used in conjunction with my Midi BLE Pedal, but I thought I'd add a few more ideas for a volume, or tone pedal.
Enjoy!
Volume Pedal
Parts
- All Parts printed, including the Double 1/4" Mount Chassis
- 2 x 1/4" Mono Jacks
- 10K Potentiometer
TODO: Wiring diagram
Tone Pedal
Parts
- All Parts printed, including the Double 1/4" Mount Chassis
- 2 x 1/4" Mono Jacks
- 10K Potentiometer
- Tone Capacitor
TODO: Wiring diagram
Wah or Other Passthrough Pedal
Parts
- All Parts printed, including the Double 1/4" Mount Chassis
- 2 x 1/4" Mono Jacks
- 10K Potentiometer
- Wah, or other Sound Circuit
TODO: Wiring diagram
Expression Pedal
Parts
- All Parts printed, including the Single 1/4" Mount Chassis
- 1/4" Stereo Jack
- 10K Potentiometer
TODO: Wiring diagram
General Parts List
- Potentiometer
- 1 x 1/4" Stereo Jack (for an expression pedal)
- 2 x 1/4" Mono Jacks (for a volume pedal, tone pedal, wah pedal, or any other pedal, where the wound passes through it via in/out)
- Tone Capacitor
Note from the Creator
I strongly believe that things like this should be freely available on the internet, but I also believe that appreciation should be shown if you get use out of it, or find it useful. At the very least, click "like" on this project, and if you feel so inclined to make a small donation to the creator, please click the donate button below...
...thanks, and happy printing!!!
Category: DIY