Pikachu Santa Hat door corner decor
No AMS Colour change .3mf profile uploaded.
How I print on X1C
- Start print with Black
- Print will pause at the start of layer 51, Hit “close” on pause pop up screen. Filament > unload. After unloading go to temperature screen and set nozzle to 220. Insert WHITE filament and manually extrude until pure white. Hit resume print.
- Print will pause at the start of layer 54, Hit “close” on pause pop up screen. Filament > unload. After unloading go to temperature screen and set nozzle to 220. Insert YELLOW filament and manually extrude until pure white. Hit resume print.
- Print will pause at the start of layer 56, Hit “close” on pause pop up screen. Filament > unload. After unloading go to temperature screen and set nozzle to 220. Insert RED filament and manually extrude until pure white. Hit resume print.
Update: 2023/11/10 I removed pikachus right hand (the little yellow bit by the pom pom) and offset the vertical piece more to the right and change it from 10mm wide to 5mm wide to make it less obvious. Thickened the white part so there's 3 layers to help block the infill below.
Only scale on X & Y axis, Scaling Z while make the pauses wrong. The back is 10mm thick and with the color changes its 11.2 thick overall
The whole thing is 200mmx200mm on the build plate