Corner Shelf / Eckregal
Boost
27
58
9
Print Profile(2)
0.16mm layer, 2 walls, 10% infill
Designer
11.5 h
3 plates
0.24mm layer, 2 walls, 10% infill
7.3 h
3 plates
Boost
27
58
9
0
86
81
Released
Comment & Rating (9)
All
Print Profile
0.16mm layer, 2 walls, 10% infill
Thank you.
0
Reply
Print Profile
0.16mm layer, 2 walls, 10% infill
Excellent print with no issues at all and fit to the walls perfectly. I juts cut the back a little to fit the cable holder.
0
Reply
Print Profile
0.16mm layer, 2 walls, 10% infill
The print came out very well but before printing it I did change some things: supports from normal to tree, and I only supported the bottom cable slot, there is actually no need to support the top at all since it is all bridging and this printer is a bridging rockstar. I also ran 0.24 layer height, saved a ton of time, the .16 is definitely overkill. Overall the print was pretty easy and does what it says on the tin.
1
Reply
why doesnt makerworldand all of these sites show us how many grams of filament?> the filament grams should be a number IN the title!!!!
The designer has replied
0
Reply
You can see it for the full print profile or for each plate individually.
1
Reply
Print Profile
0.16mm layer, 2 walls, 10% infill
Print is good.
(Edited)0
Reply
Print Profile
0.16mm layer, 2 walls, 10% infill
0
Reply
Print Profile
0.16mm layer, 2 walls, 10% infill
0
Reply
Print Profile
0.16mm layer, 2 walls, 10% infill
0
Reply
No more
License
This work is licensed under a
Creative Commons Attribution-NoncommercialRelated Models
© 2024 MakerWorld