Utility Knife (Perfect Blade Fit)
Copyright Claim
Utility Knife (Perfect Blade Fit)
Boost
3
5
2
GIF
Print Profile(2)
PLA Pro 0.2mm layer, 4 walls, 100% infill
Designer
34 min
2 plates
PETG 0.2mm layer, 4 walls, 100% infill
Designer
45 min
2 plates
Boost
3
5
2
0
8
23
Released
Description
**PLEASE BE CAREFUL THIS IS A REAL KNIFE ONCE A BOX BLADE HAS BEEN ADDED. YOU CAN SERIOUSLY HURT YOURSELF ALWAYS PRACTICE PROPER KNIFE SAFETY AND KEEP OUT OF REAR OF KIDS**
*ONLY USE DESIGNER PRINT PROFILES*
(Two have been provided PETG,PLA Pro)
Utility knife I designed to work with standard box blades. Blades can be purchased at local hardware stores or on Amazon.
Comment & Rating (2)
All
Not bad, but I had to put a bit of tape inside the blade holder to keep the blade from falling out constantly.
The designer has replied
0
Reply
I would suggest calibrating your filament flow rate. sounds like you might be slightly under extruding. you shouldn’t need to do anything beside add a blade.
0
Reply
No more
License
This work is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRelated Models
© 2024 MakerWorld